9/20/2023 0 Comments Asus rt ac66u cannot access menu![]() ![]() Go into Administration->Restore/Save/Upload.Disconnect the LAN cable and connect to the AC66U via wireless.I figured if I switched it into the AP mode (with a wired LAN connection from my switch to the WAN port on the ACC66U), I could use my main PC’s browser to walk it through the setup.įirst time through, no luck. One of the problems I noticed in using my iPhone/iPad to connect to the AC66U after it would reboot is that the web UI wouldn’t always load completely, or the router would act like it disconnected when I would get 3/4 of the way through the wizard to set it into AiMesh node mode. I remembered seeing a setting that said “Access Point(AP) mode / AiMesh Router in AP mode” on the Operation Mode screen. ![]() ![]() The entire time, I tried setting the AC66U to either AiMesh Node, or it would reboot into Wireless router mode / AiMesh Router mode (default) after the firmware resets. Literally the next morning, about 6 hours into it, I upgraded both routers back to the latest firmwares (Version 3.0.0.4.384.21140 on both). I wasted a few hours of downgrading firmware versions on both the AC66U and the GT-5300. I went into the AC66U Mode page and switched it from Router to AiMesh Node. After the router rebooted, I connected to the new 5ghz network wirelessly and upgraded the firmware via upload from my iPad. I ignored an error that there was no network cable plugged in, and it went right on through. So, I figured that even though this was a new unit, the firmware on the AC66U may not be the latest and greatest (even though it said it supported AiMesh and manufacture date was March 2018), I downloaded the latest firmware to my iPad, then connected to the AC66U and ran through the setup wizard and told it to use the normal Router mode. and they sent me back the same generic reasons from the error message and to please try again!) (As an aside, I sent a very detailed message to ASUS tech support with most of what I tried below, including firmware versions, logs, etc. It found the new router, but after around 40% complete, I got an error message that setup could not be completed and it listed several generic reasons. Once it rebooted, I then went into the AI-Mesh management feature on the GT-5300, and clicked the Search button on the “Find AiMesh Node” screen. Wrong! So, I first tried to just turn on the brand new AC66U, connected to it via wireless, followed the wizard to set it up as a Mesh Node. Note: For ease of typing/clarity, below I will refer to the RT-AC66U_B1 as the AC66U and the GT-AC5300 as the GT-5300.īeing the glutton for punishment I am, I took faith in that a mesh system that’s a year or so old should work out of the box. These range extenders worked substantially better than the previous TP-Link N300 Wi-Fi Range Extenders (TL-WA860RE) in regards to signal, but the main problem I had with the RE55s was that any time the power went out or I had to reset my GT-5300, I would have to power cycle the Range Extenders to get them to come up again. My network consists of an ASUS GT-AC5300 and two TP-Link AC1200 Wi-Fi Range Extenders (RE355). I had some difficulty adding a brand new ASUS RT-AC66U B1 to my home network. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |